Instructions for Use:

Read all information and instructions carefully before proceeding.

Step One:
Remove the screw cap from the plastic Collection Container and fill with lukewarm tap water to the top of the temperature strip. The tap water should not be too hot or too cold. Do not dispose of cap.

DO NOT open Synthetic Sample vial until ready for use. DO NOT open Heat Activator vial until ready for use.

The Synthetic Sample and Heat Activator are stable for one year in dry form if not opened.

Step Two:
Add entire contents of Synthetic Sample vial to water in Collection Container (the Synthetic Sample can be mixed with water up to six hours prior to use). Within minutes of submitting the sample, add entire contents of Heat Activator vial to solution. Screw cap on Collection Container and gently swirl the contents to completely dissolve Synthetic Sample and Heat Activator.

Step Three:
Read temperature strip on Collection Container to ensure that solution is within the acceptable temperature range of 90°F–100°F. Solution MUST be within the proper temperature range of 90°F–100°F. Due to the temperature variations in tap water when filling Collection Container, if solution is above 100°F, let the solution cool by sitting Collection Container on a flat surface until temperature drops. If solution is below 90°F, keep Collection Container close to your body to raise temperature. Remove screw cap from Collection Container and pour needed amount of solution into sample cup.